Drawmer HQ Series Manuel de l'opérateur télécharger pdf (Page 7)

DRAWMER HQ OPERATOR’S MANUAL

Preset Location

PRESET:

Three illuminated switches are

located left centre of the control

surface titles P1, P2 and VARI.

When ‘VARI’ is pressed and

illuminated the volume is controlled

by the knob and increases/

decreases with rotation.

When P1 or P2 are pressed the

volume level jumps to a predefined

level, to enable the studio to

operate at the volume that they

prefer, for instance, to ensure that

there is enough level in a mix - this level is altered via the two small potentiometers as located on the rear of the

remote. Use a small screw driver to adjust whilst watching the level seen in the display.

SPEAKERS:

As with the HQ the HQ-r has the ability to switch through the A/B outputs on the rear, to provide A/B comparisons

for example. The switches are as follows: ‘A’ (output A active, B mute), ‘B’ (output B active, A mute) and ‘A+B’ (both

A and B active). To mute both the outputs see ‘Mute’

OUTPUT:

DIM:

With the DIM button active the current output is attenuated to lower the overall output level to the speakers. This

process varies according to the current volume level and will effect louder volumes more than quieter.

MUTE:

With the MUTE button active the output at the speakers is attenuated to -100dB. The switch is conveniently located

at the front of the unit for easy, emergency access. When active the ‘MUTE’ led on the front of the HQ and HQ-b will

also light to show that the unit is being controlled elswehere.

MONO:

With the MONO button active the signal is combined so that both outputs produce the same signal.

1 2 3 4 5 6 7 8

Pas de commentaire

Drawmer HQ Series Manuel de l'opérateur Page 7