Drawmer HQ Series Manuel de l'opérateur télécharger pdf (Page 4)

DRAWMER HQ OPERATOR’S MANUAL

On the rear of the HQ there

are two RJ45 connectors that

allow it to be remotely operated,

via the HQ-r remote and also to

link several HQ’s together.

To use the remote option,

ensure that all units are

switched off, then plug in the

cable that is supplied in the box

(using an alternative cable

could damage either the remote

or HQ) between the remote and

the top “IN/REMOTE”

connector on the unit - this will

then become the master

control and bypass any relevant

front panel controls (see also

‘Control Description: mute’, and

‘Safety Features’).

Several units can be linked together, to provide a distribution

system, or a 5.1 / 7.1 surround setup with only one master

control - to do this a standard CAT5e cable should be

connected between the “THRU’” and “Link/Remote”

connectors - the top “thru’” in the chain being the master.

Ensure that all unit’s are turned off when connecting.

Audio is not passed down the CAT5e cable, only the unit

control, so each unit will require it’s own individual input as

selected via the “source” on the master unit - this source will

be repeated for all units i.e. AUX1.

Note that in no way should the HQ, HQ-r or HQ-b ever be connected directly to

any type of ethernet network (or similar) - it will in no way interact with the

network, and may cause severe damage if done so.

At no time should you

directly connect “IN/

REMOTE” of one unit to

“IN/REMOTE” of another.

Neither should you

connect “THRU” of one

directly to “THRU” of

another.

Doing so could harm either

unit and would negate

warranty.

REMOTE OPERATION & LINKING FOR SURROUND

1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire

Drawmer HQ Series Manuel de l'opérateur Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Amplificateurs audio Drawmer HQ Series